Flat Wire Staple 21g X 0.7mm X 8mm Jt21 1000pc C/steel For Tcsg0500

Extra Information

• Check the thickness of your material stack (face and backing combined) to ensure the 8 mm leg length offers enough penetration; choose a longer leg if needed.
• Keep your staple gun magazine clean and dry—dust or rust in the feed can cause mis-feeds or jams.
• For fabric or insulation fixings, place a hard board behind the material during stapling to avoid pull-through or deformation of the crown area.

Features

• 21-gauge (21 g) wire thickness Suitable for lighter-duty staple applications and general material fixings.
• 0.7 mm wire diameter Ensures sufficient penetration while minimising damage to backing material.
• 8 mm leg length Ideal for attaching materials to thinner substrates, boards or panels.
• 1 000-piece pack Large quantity means less frequent reloading, better efficiency on-site.
• JT21 staple format compatibility Ensures seamless use with Tork Craft JT21 staple guns and standard kits.

Benefits

• High-volume supply The large count pack supports continuous stapling without severe interruptions.
• Reduced risk of over-penetration The 8 mm leg length is well-matched to thinner materials, reducing damage behind the fixings.
• Good value for money Bulk pack provides cost-efficient consumables for finishing, trim or backing fix tasks.
• Instant compatibility Works straight out of the box with JT21 staple guns—no special adaptation required.

Safety

• Wear eye protection when using a stapler—staples or fragments can eject at high speed.
• Ensure the stapler is pressed flush and square to the workpiece before firing to avoid mis-feeds or bent staples.
• Keep your fingers and body clear of the staple exit area; mis-feeds or tool malfunction can cause serious injury.
• Use only staples that match the tool’s specification—including gauge, leg length and format—to maintain safe operation and reliable fixings.

Specifications