Magnetic Bit Holder 150mm One Touch Carded 1/4' Hex

Extra Information

• Compatible with standard 1/4' hex insert bits (25–50 mm and longer).
• For best results, seat the bit fully until the locking collar clicks; pull the sleeve to release.
• Use with a quality bit set matched to the fastener type to minimise cam-out.

Features

• 150 mm extension — extra reach for deep or obstructed fasteners.
• One-touch quick-release sleeve — rapid bit changes with positive lock-in.
• Magnetic retention — holds 1/4' hex bits securely and stabilises screws.
• 1/4' hex shank — fits standard drill/drivers and bit holders.
• Carded retail packaging for easy identification and storage.

Benefits

• Faster workflow: Swap bits in seconds without fiddling with the chuck.
• Better access: Slim 150 mm form helps reach confined or recessed fasteners.
• Fewer drops: Magnet assists with screw pickup and starts.

Safety

• Disconnect the driver before fitting/removing bits.
• Ensure the bit locks in place; tug to confirm before use.
• Avoid excessive side-load that can bend or snap bits.
• Wear eye protection; small fasteners can eject under load.

Specifications