Annular Hole Cutter Tct 18 X 35mm Weld Shank 19.05mm

Extra Information

• Use in magnetic-base drills or compatible arbors in drill presses.
• Requires a pilot pin for centering and slug ejection (sold separately).
• For best results on stainless and harder grades, apply suitable cutting fluid and moderate feed.

Features

• 18 mm diameter — accurate holes for bolts, fittings and conduit.
• 35 mm cutting depth — covers common plate and structural sections.
• 19.05 mm (3/4") Weldon shank — secure two-flat drive for most magnetic drills.
• TCT (tungsten-carbide-tipped) teeth — long life in abrasive and hard materials, including stainless.
• Thin-wall, multi-flute body — fast penetration with efficient chip evacuation.

Benefits

• Drills faster than twist bits by removing less material.
• Cleaner holes with reduced burrs and better finish, saving post-processing time.
• Long service life thanks to wear-resistant carbide tips.
• Less effort — lower feed pressure needed on vertical and overhead work.

Safety

• Wear eye, ear and gloves protection; use cutting fluid to control heat.
• Ensure magnet adhesion is secure before drilling; tether the drill when working at height.
• Do not use hammer action; maintain steady, straight feed and allow the slug to eject.
• Disconnect power before changing cutters or pilot pins.